1. Quick Summary
A heat pump does not create heat from electricity. It moves heat that is already present in outside air, ground or water, using a compressor and a refrigerant cycle. The electricity powers the moving, not the heating, which is why the heat delivered can exceed the electrical energy consumed.
The ratio is called the coefficient of performance. A unit delivering four kilowatts of heat while consuming one kilowatt of electricity has a coefficient of four, and the electricity is not wasted — it ends up as heat too.
Rated figures on specification sheets are measured under defined test conditions. Real-world performance depends heavily on the temperature difference the machine works across and on how the distribution system is designed.
The technology is well established rather than experimental. The active engineering problems are about cold-climate performance, refrigerant choice, installation quality and electrical grid impacts.
2. What It Means
The thermodynamic reason this works is that heat is not being generated but relocated. The compressor raises the temperature of a refrigerant so it can release heat into the building; the refrigerant then expands, cools below the outdoor temperature, and absorbs heat again from outside.
Efficiency falls as the temperature lift increases. Moving heat from ten degrees outside to thirty-five degrees inside is easy; moving it from minus fifteen to thirty-five is much harder, which is why cold-climate performance is the main engineering focus.
3. Why It Happens
Carnot limits set an upper bound, and real machines achieve some fraction of it. Every additional degree of temperature lift reduces the achievable ratio, so the design goal is to keep output temperature as low as the heating system will accept.
This is why heat pumps pair so well with underfloor heating and oversized radiators. They deliver lower-temperature water than a boiler typically provides, and a system designed for high flow temperatures forces the pump to work harder than necessary.
Frost and defrost cycles cost energy in cold, humid conditions. A unit must periodically reverse to melt ice off the outdoor coil, and those cycles are a real component of seasonal performance that laboratory ratings may understate.
Refrigerant choice matters for another reason. Many conventional refrigerants are potent greenhouse gases if leaked, so the industry is shifting toward lower global-warming-potential alternatives, some of which are mildly flammable and require design changes.
4. Real Examples
Ground-source systems: buried loops see stable ground temperature year-round, so they avoid the worst cold-air penalty at the cost of installation expense and groundworks.
Cold-climate air-source units: variable-speed compressors and improved vapour injection maintain useful output well below freezing, narrowing the gap with combustion heating.
Hybrid systems: a heat pump handles most of the season and a boiler covers the coldest hours, which can be a pragmatic retrofit where electrification is expensive.
Water heating: heat pump water heaters move heat into a tank, and are among the simplest and most clearly beneficial applications.
5. How It Affects Us
Installation quality dominates outcomes. Correct sizing, low flow temperatures and good controls matter more to real efficiency than the choice between comparable brands.
Insulation is the cheapest efficiency measure. Reducing heat loss lets the system run at lower flow temperatures, which raises efficiency and reduces running cost simultaneously.
Grid implications are about timing, not just total consumption. Widespread electrification of heating shifts load into cold evenings, which is when electricity systems are often most strained.
Whether a heat pump saves money compared with gas heating depends on the local ratio of electricity to gas prices, which varies enormously between markets.
6. Key Takeaways
- Heat pumps relocate existing heat rather than generating it, which is why output can exceed electrical input.
- Efficiency falls as the gap between source and delivery temperature widens.
- Low-temperature distribution systems — underfloor heating, larger radiators — materially improve performance.
- Defrost cycles and cold-climate operation explain much of the gap between rated and seasonal figures.
- Proper sizing, insulation and controls usually matter more than equipment brand.